GW Instek ASR-2000 Series - Page 55

OPERATION
55
4. The air filter is positioned
in the rear side of frame
of air inlet. Simply rinse it
or replace the filter with a
new one based on the
actual status.
5. Repeat the previous steps conversely to
reinstall the air inlet with new filter back to
unit.
6. The unit is now ready to power up.
Note
Please clean regularly to avoid damaging the internal
components of the machine.
WARNING
The procedure above should only be attempted by
competent persons.
Ensure the AC power cord is not connected to power
before operation.