GW Instek LCR-8000G Series - Command Set; Command Set System Command

REMOTE CONTROL
113
Command Set
System command
*cls
Clears the Event Status Register and associated
status data structure.
*ese <NR1>
*ese?
Sets or returns the current contents of the Standard
Event Status Enable Register as an integer in the range
0 to 255.
*esr?
Returns the current contents of the Standard Event
Status Register as an integer in the range 0 to 255.
It also clears ESR.
*idn?
Returns the LCR identification: Manufacturer,
Model No, Serial No, Firmware version.
Example: GW INSTEK, 8101, 0, 2.04
*loc
Sets the instrument to local state.
*opc
Sets the OPC bit of the ESR register.
*opc?
Always returns 1 as instrument commands are
always processed sequentially.
*opt?
Returns the hardware options installed in the
instrument.
Example: 1MHz, GPIB, RS232, GRAPH MODE
*rst
Resets the LCR-8000G.
*sre <NR1>
*sre?
Sets or returns the current contents of the Service
Request Enable Register as an integer in the range 0 to
63 and 128 to 255.
:stat:oper:con?
Reads Status Operation Condition register.
:stat:oper:enab
<NR1>
Sets Status Operation Enable register.
:stat:oper:even?
Reads Status Operation Event register.
w ww . . co m
information@itm.com1.800.561.8187