BASIC MEASUREMENT
57
Select Repetitive measurement
The data capture can be manually controlled
(Single) or automatically updated (Repetitive).
In single measurement, the measurement is
activated by pressing the Trigger key.
In repetitive measurement, the measurement is
automatically done and the display is updated
according to the speed (timing) setting.
1. Press the Sing/Rep key repeatedly
until the “Repetitive Mode” message
appears on the display.
2. The measurement update indicator (*) keeps
blinking and the measurement result is updated
on the display.
MEASUREMENT MODE
0.01234
0.2179
nS
D
*7
–
3. Press the Left/Right key repeatedly
to move the cursor to measurement
speed.
4. Press the Up/Down key repeatedly
to select the time per update.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
