GW Instek LCR-8000G Series - Multi-Step Program Run; Multi-Step Run Run Program

PASS-FAIL MODE
81
Multi-Step Program Run
Run program
Panel operation
1. When editing is completed, press F6
(Run) to run the multi-step program.
The display changes to program
running mode.
F 6
MULTI STEP MODE
F 1
PROGRAM: Demo
Run–
Start
F 6
SET
2. Press the Sing/Rep key to select
Single (manual trigger) or Repetitive
(automatic trigger).
Sing/Rep
Manual
trigger
Manual trigger
Starts running the program
when the Trigger key or F1
(Start) is pressed.

F 1
Auto
trigger
Auto trigger
Starts running the program when the
LCR-8000G detects the DUT is
connected to the fixture (scans the
fixture continuously). Manual
triggering is also available.
w ww . . co m
information@itm.com1.800.561.8187