GW Instek LCR-8000G Series - Page 133

APPENDIX
133
≦100 kHz O/S Trimming Point List
The frequency of the extra trimming point is the measurement
frequency you were using before entering the calibration mode.
“O/S Trim Error!” warning will still appear after running a ≦100
kHz trimming if you choose to use a measuring frequency higher
than 100 kHz or other than where you were when you ran the ≦100
kHz trimming.
LCR Models
LCR-8101G
LCR-8105G
LCR-8110G
Trimming Point
10 points
10 points
10 points
1
20 Hz
20 Hz
20 Hz
2
100 Hz
100 Hz
100 Hz
3
300 Hz
300 Hz
300 Hz
4
1 kHz
1 kHz
1 kHz
5
3.3 kHz
3.3 kHz
3.3 kHz
6
10 kHz
10 kHz
10 kHz
7
20 kHz
20 kHz
20 kHz
8
50 kHz
50 kHz
50 kHz
9
100 kHz
100 kHz
100 kHz
10
Extra Trimming
Point
Extra Trimming
Point
Extra Trimming
Point
w ww . . co m
information@itm.com1.800.561.8187