GW Instek LCR-8000G Series - Page 72

LCR-8000G Series User Manual
72
Parameters
No. of step
Maximum 30 for each program
No. of program
Maximum 64
Drive Voltage
(1mV step)
10mV ~ 2V (DC or AC≤3 MHz)
10mV ~ 1V (AC>3 MHz)
Frequency
20Hz ~ 1MHz (LCR-8101G)
20Hz ~ 5MHz (LCR-8105G)
20Hz ~ 10MHz (LCR-8110G)
Bias
Reserved item: internal use only
Speed
Max, Fast, Med, Slow
Hi / Lo Limit
Follows the measurement range
Delay
0 ~ 9999ms, 1ms step
Single trigger
Program runs when the Trigger
key or F1 (Start) is pressed.
Automatic
trigger
Program runs when the LCR-
8000G detects the DUT.
w ww . . co m
information@itm.com1.800.561.8187