GW Instek LCR-8000G Series - Page 98

LCR-8000G Series User Manual
98
Backspace
All clear
Clear
If a wrong unit is entered, the value is cancelled.
Unit Mismatched
If the entered Hi level is lower than the Lo level,
the two values are swapped.
Hi and Lo Swapped
Set Lo level
6. Press the Up/Down key to move the
cursor to Lo percentage and repeat
the same step.
Cs Lo: -19.500%
Range
–1.0x10
12
(Tera) ~ 1.0x10
12
(Tera) %
Set Nominal
7. Press the Up/Down key to move the
cursor to Nominal.
Nominal:1.0000mF
8. Use the numerical keys to enter the nominal
value on which the Hi and Lo percentages are
based.
Range
According to each measurement item
(see page38).
1.2mΩ
m
Ω
Enter
1.5kH
Enter
H
k
Backspace
All clear
Clear
If a wrong unit is entered, the value is cancelled.
Unit Mismatched
w ww . . co m
information@itm.com1.800.561.8187