Hach BioTector B7000 User Manual

Page 112
Data Program
PRINTER, PC, MMC/SD CARD
 These menus allow the user to program three separate output
device communication port configuration profiles, which are
PRINTER, PC and MMC/SD flash card.
 The functions described below covers all programming options
for each device. Some devices (e.g. MMC/SD Card) may have
less programming functions.
PRINT MODE ENGINEERING
 PRINT MODE specifies the format in which the data will be sent
over the communication port to all output devices. The available
modes are STANDARD (includes time, date and calibrated
reaction data etc.), and ENGINEERING (includes un-calibrated
data, temperature and atmospheric pressure, pump diagnostic
information, liquid phase measurement information etc. in
addition to the STANDARD data).
REACTION ON-LINE NO
 REACTION ON-LINE enables (YES) or disables (NO) the
automatic printout of the reaction result at the end of each
reaction.
FAULT ON-LINE NO
 FAULT ON-LINE enables (YES) or disables (NO) the automatic
printout of a fault or warning log as soon as it occurs.
CONTROL CHARS NO
 CONTROL CHARS enables (YES) or disables (NO) the control
characters sent with the RS232 data for the output device
operation.
BAUDRATE 9600
 BAUDRATE (9600 by default) specifies the data communication
baudrate for Printer and PC output devices. The baudrate range
is between 2400 and 115200.
FLOW CONTROL NONE
 FLOW CONTROL defines the data flow control mechanism used
between BioTector and the connected Printer or PC output
devices. The available options are NONE (no flow control),
XON/XOFF (inbound XON/XOFF flow control) and LPS1/10 (1 to
10 lines of data sent per second).
DECIMAL POINT
 DECIMAL specifies whether a POINT (.) by default or a COMMA
(,) character represents the decimal point in the downloaded
reaction data files for all output devices.
Information
CONTACT INFORMATION
 Contact menu displays the contact details of the manufacturer
and if programmed the contact details of the distributor.
SOFTWARE
VERSION 02.01.00
 VERSION displays the system software revision number.
DATE May 5 2010
 DATE displays the system software revision date.
IDENTIFICATION
BS4AN2 2.01 347
 IDENTICIFATION displays the specific identification number
(system serial number) for the BioTector.

Hach BioTector B7000 Specifications

General

Brand	Hach
Model	BioTector B7000
Category	Measuring Instruments
Language	English