Special precautions are needed when working with chemical reagents, both
when renewing reagents and when dealing with leaks or spills. Some reagents
can cause chemical burns and may cause injury or death if swallowed. Please
refer to the symbols and codes on the reagent containers.
Use of 25 liter containers is recommended for each BioTector reagents. Figure 14 below shows the setup and
typical connection ports of BioTector TOC TN analyzer reagents: Acid (1.8N Sulfuric Acid), Base (1.2N
Sodium Hydroxide), TN Cleaning Solution, DI Water, and Zero Water (DI Water for Zero Calibration). See
Section 6 Reagents and Calibration Standards for further details.
Figure 14 BioTector reagent setup and connections
To Next Page
Loading...
Need help?
General
