Assemble the remote indicator
1. Install the cable strain relief as follows:
a. Put the cable in the vertical channels in the backplate.
b. Put the cable strain relief on the backplate. Align the screws with the screw holes.
c. Tighten the screws.
Gently pull the cable to make sure that the cable is held securely by the cable strain relief.
2. Connect the remote indicator cable to the housing as follows:
a. Remove the green 8-pin connector from the backplate.
b. Connect the remote indicator cable to the housing.
c. Align the four pins of the housing to the four holes of the backplate.
English 35
To Next Page
Loading...
