3. Select Date.
4. Enter the current date.
To erase characters, select and push ok.
5. Select Continue.
6. Select Time.
7. Select am or pm.
8. Enter the current time.
To erase characters, select and push ok.
9. Select Continue.
Configure the network settings
Enter the TCP/IP addresses of the analyzer, subnet mask, default gateway and network time
protocol (NTP) server(s). The TCP/IP addresses are supplied by the network administrator.
1. Push menu.
2. Select Settings.
3. Select an option. Refer to Figure 17.
Option Description
Static IP Sets the TCP/IP address of the analyzer.
Subnet IP Sets the TCP/IP address of the subnet mask for the analyzer.
Gateway IP Sets the TCP/IP address of the default gateway for the analyzer.
Primary NTP IP (Optional) Sets the TCP/IP address of the primary network time protocol (NTP) server
for the analyzer. The NTP server supplies the date and time to the analyzer.
Secondary NTP IP (Optional) Sets the TCP/IP address of the network time protocol (NTP) server for the
analyzer that is used if communication with the primary NTP server is lost.
Note: Make sure to configure the primary NPT IP before the secondary NTP IP is
configured.
4. After the TCP/IP addresses are entered, select Reset.
5. When the reset is complete, push back.
Figure 17 Settings Screen—Static IP
46 English
To Next Page
Loading...
