Hach CM130 - Analyzer Electrical Installation; Remove the Door (Optional); Lower the Front Panel

Analyzer electrical installation
Connect the remote indicator cable and an energized Ethernet cable to the analyzer.
Items supplied by the user:
Cross-slotted
screwdriver
CAT5 cable
stripper
Wire
strippers
Flat-bladed
screwdriver,
small
Flat-bladed
screwdriver,
medium
Crimper
tool
Remove the door (optional)
N O T I C E
To keep the enclosure environmental rating, make sure to reinstall the door when this procedure is complete.
Remove the door for easier access to the cable fittings. Refer to Figure 13.
1. Open the door.
2. Lift the door off the hinges.
Figure 13 Door removal
Lower the front panel
D A N G E R
Electrocution hazard. Remove power from the instrument before this procedure is started.
Lower the front panel to get access to the electrical connectors. Refer to Figure 14.
1. Loosen the two captive screws on the top corners of the front panel.
2. Lower the front panel.
English
37