Items to collect
Collect the items that follow to install the instrument. The items that follow are supplied by the user.
Get the TCP/IP addresses of the analyzer, subnet mask, default gateway and network time protocol
(NTP) server(s) from the network administrator to configure the instrument. Refer to Configure the
network settings on page 46.
Fasteners
for the
analyzer
(4x)
12
CAT5e/CAT6 cable
for remote indicator
connection
13
Ethernet
cable for
network
connection
13
Fasteners
for the
remote
indicator
(2x)
14
Sample filter (Y-
strainer) for ¼-inch
OD tubing,
100 mesh, 149 µm
or smaller
CAT5 cable
stripper
Cross-
slotted
screwdriver
(Optional) Shut-off
valve for ¼-in. ID
tubing
Tape
measure
Flat-bladed
screwdriver,
small
Level
Safety
glasses
Flat-bladed
screwdriver,
medium
Crimper tool Wire cutters
Drill Wire strippers
Tubing
cutter
Flashlight Gloves
12
Use fasteners applicable to the mounting surface (¼-in. or 6 mm SAE J429-Grade 1 bolts or
stronger).
13
Refer to Table 1 on page 3 for specifications.
14
Use fasteners applicable to the mounting surface.
14 English
To Next Page
Loading...
Need help?
General
