136
■ Don't use gasoline, benzene, diluents, polishing powder or liquid insecticide to clean them.
■ Do not clean them with hot water of above 50°C to avoid fading or distorting.
■ Do not wipe the wind deector with water forcibly to avoid the oss falling off.
■ Wipe them with soft dry cloth.
■ Water or neutral dry cleanser is recommended if the dust cannot be removed.
■ The Wind Deector can be dismantled to clean.
Maintenance before and after Operating Season
Before Operating Season: After Operating Season:
1. Please make the following checkup:
■ There is no blockage in inlet port and outlet port
of outdoor and indoor units.
■ The ground line and the wiring are in the proper
state.
If abnormal condition occurs, consult the after-
service personnel.
2. Clean the air cleaner and the shell.
■ After cleaning, the air cleaner must be mounted.
3. Switch it on to the power.
■ After cleaning, the air cleaner must be mounted.
1. In sunny days, blowing operation can be performed
for half a day to make the inside of machine dry.
2. Switch it off.
■ Electrical power should be cut down to economize
electricity, or the machine will still consume power.
3. Clean the air cleaner and the shell.
■ Air cleaner and shell must be mounted
after cleaning. For cleaning details, refer to
Maintenance.
Install the air cleaner & Inlet guide plate
Cleaning the air outlet port and the shell
1.Install the air cleaner: The method is contrary to the method of removing the dust screen.
2.Install the Inlet guide plate: As shown below, the rack on the return air guide plate is inserted into the gear box.
The hole of gear wheel box Rack
Attention
Attention
To Next Page
Loading...
