489
Console Type
Indoor Unit
19.9 Installation
Installation of indoor unit
Necessary tools
(1) Screw driver
(2) Hacksaw
(3) Dia. 70mm hole core drill
(4) Spanner (dia. 17,27mm)
(5) Spanner (14,17,27mm)
(6) Pipe cutter
(7) Flaring tool
(8) Knife
(9) Nipper
(10) Gas leakage detector or soap water
(11) Measuring tape
(12) Reamer
(13) Refrigerant oil
■ Place where it is easy to route drainage pipe and
outdoor piping.
■ Place, away from heat source and with less direct
sunlight.
■ Place where cool and warm air could be delivered
evenly to every corner of the room.
■ Place near power supply socket. Leave enough space
around the unit.
■ Place, robust not causing vibration, where the body can
be supported sufciently.
■ To prevent interference, place it at least 1m away from
other electric machines, such as TV set, radio.
■ According to the dimension of the gure 2 shown, nail
two cement steel nails on the wall, keep 2~3 mm out.
Then hang the back of the unit on them.
■ There must be no gap between the indoor unit and
wall.
■ Remove the front panel, then use two fastening
screws to x the unit on the oor.
■ As Figure 3 shown.
■ Once refrigerant piping and drain piping connections
are completed, ll the gap of the through hole with
putty.
■ Attach the front panel and front grille in their original
positions once all connections are complete.
Selection of installation place
Selection of installation place
19.9.1 Installation Procedures
More than 100cm
More than 10cm
More than 10cm
More than 10cm
To Next Page
Loading...
