326
Choice of Blowing Wind from Blower
(when using the high performance lter)
The blower is provided with a red terminal and a white terminal. The standard wind choice has been set before
delivery. When the use of optional components, such as the high performance lter, causes the static pressure
rising, change the connection of the connector mounted on the side of the control cabinet, as shown as follows.
Standard
static
pressure
Maximal
static
pressure
80 120
White
Blue
Yellow
Red
White
Blue
Yellow
Red
One side of
control cabinet
Fan Down-lead End
connector,
white
White
Black
White
Blue
Red
White
Blue
Yellow
Red
White
Red
High-speed blowing wind
Standard blowing wind (at delivery)
Fan Down-lead End
(a) Keep a gradient (1/50-1/100) of the drainpipes and avoid lobbing or curving.
(b) When connecting the drainpipe to the equipment, don't apply too much force on one side of the equipment.
Meanwhile, the piping should be positioned as close to the equipment as possible.
(c) For the drainpipe, the general purpose hard PVC tube can be purchased at local shops. During the connection,
insert the end of PVC tube into the wash port and fasten it with drainage hose and thread clip. Binding agents
shouldn't be used to connect the wash port and drainage hose.
Hanging bolt
Heat insulator
Gradient of 1/100 or over
Air outlet port
Avoid lobbing
Avoid curving
Don't put pipe
into water
4. Drainpipe
Drainpipe
Gas pipe Liquid pipe
To Next Page
Loading...
