390
(a) Keep a gradient (1/50-1/100) of the drainpipes and avoid lobbing or curving.
• Proper Piping • Improper Piping
(b) When connecting the drainpipe to the equipment, don’t apply too much force on one side of the equipment.
Meanwhile, the piping should be positioned as close to the equipment as possible.
(c) For the drainpipe, the general purpose hard PVC tube can be purchased at local shops. During the connection,
insert the end of PVC tube into the wash port and fasten it with drainage hose and thread clip. Binding agents
shouldn’t be used to connect the wash port and drainage hose.
Air outlet port
Avoid curving
Don't put pipe
into water
1.5m ~2 m
Gradient of 1/100 or over
Hanging bolt
Avoid lobbing
Heat insulator
0~200
Static Pressure Range
Static PressureR ange
unit:P a
512mm
drainp ipe
473mm
414mm
gasp ipe
liquid pipe
468mm
4. Drainpi pes
AD072-302MQERA
468mm
405mm
738mm
30mm
30mm
467mm
AD362-542MQERA
To Next Page
Loading...
