536
Items with this warning sign concerning the product's safety and the personal security must be
performed strictly.
Items with this forbidding sign refer to absolutely forbidden behaviors. If not, they may cause
machine damage or endanger operator's personal safety.
Clean the lter regularly.
Cooling or heating performance will be degraded
if the lter is blocked, resulting in large power
consumption, failure, and water dripping
at freezing.
Don't touch the outlet while the ap is moving. Don't
put anything in the grid in case danger may occur.
Avoid cold wind from blowing out.
During heating running, the fan of indoor units will
not rotate immediately as to prevent cold wind from
blowing out.
Changing Wind Speeds:
In the state of refrigerating, with automatic blowing
mode, the wind speed automatically decreases when
the room temperature approaches the setting.
In the state of heating, when the room temperature
reaches the setting temperature the compressor
stops working and the fan turns to low wind or
stops. Wind speed changes automatically in the
dehumidifying mode.
Regulating Wind Direction:
It is recommended not to make the wind deector
downwards for a long time to avoid condensation at
air outlet port during refrigerating or dehumidifying.
Water dropping might appear at the air outlet port in
refrigerating or dehumidifying mode.
Defrosting:
During heating running, the air conditioner would
defrost automatically if there is frost on heat
exchanger of outdoor units.
Do not rotate fans of both indoor units and outdoor
units during defrosting.
After nishing defrosting, the air conditioner will
resume running automatically.
The machine operation must be controlled by the
control.
Hints:
As air conditioners absorb heat from the environment
and release it to the room, heating effects will be
inuenced by the temperature in and out of the room.
Wait for a monent
To Next Page
Loading...
