Haier AB072MRERA - Page 593

585
Dip Switch Setting
(2) Denition and description of SW03
Note 2:
• Set the address by dip switch when connecting the centralized controller or gateway or charge system.
• Central control address =communication address + 0 or +64.
• SW03_ 2=OFF, Central control address =communication address+0=communication address.
• SW03_ 2=ON, Central control address = communication address+64 (applies when
central controller is used and there are more than 64 indoor units).
• When the 0151800161 and 0010451181A PCB in one system, address must be set by dip switch. Set
SW03_1=ON and SW03_ 2=OFF; SW03_3, SW03_ 4, SW03_5, SW03_6, SW03_7 and SW03_ 8 are address
codes which are set according to actual address.
• Address setting function of wired controller for slim duct is unavailable.
(3) Denition and description of SW08
SW08_1
ON One by one
WIFI control mode
OFF One by multi
SW08_2
ON
Generally room card is disabled and there is no linkage
control in the unit with total heat exchanger
Room card contact, total heat exchanger
linkage
OFF
Room card is enabled, there is linkage control in the
unit with total heat exchanger
SW08_3
ON General (default)
Selection of indoor unit priority
OFF High priority
SW08_4
ON Ordinary unit
Isothermal dehumidication type indoor
units selection
OFF Isothermal dehumidication unit
SW03
Set the
communication
and central
control address
by dip switch(note
2)
[1] [2] [3] [4] [5] [6] [7] [8]
Communication
address
Central control
address
ON OFF OFF OFF OFF OFF OFF OFF
0
(default)
0
(default)
ON OFF OFF OFF OFF OFF OFF ON 1 1
ON OFF OFF OFF OFF OFF ON OFF 2 2
… … … … … … … … … …
ON OFF ON ON ON ON ON ON 63 63
ON ON OFF OFF OFF OFF OFF OFF 0 64
ON ON OFF OFF OFF OFF OFF ON 1 65
ON ON OFF OFF OFF OFF ON OFF 2 66
… … … … … … … … … …
ON ON ON ON ON ON ON ON 63 127
OFF … … … … … … … Set the address automatically (default)