611
Dip Switch Setting
Dip switch introduction
SW01 is used for indoor unit group control address setting and capacity selection. SW03 is used for indoor
unit address setting (including physical address and central address).
(1) Description of SW01
SW01_1
SW01_2
SW01_3
SW01_4
Wired
control
address
[1] [2] [3] [4] Wired control address
OFF OFF OFF OFF Master unit in group control
OFF OFF OFF
ON Slave unit 1 in group control
OFF OFF
ON OFF Slave unit 2 in group control
OFF OFF
ON ON Slave unit 3 in group control
… … … … ……
ON ON ON ON Slave unit 15 in group control
SW01_5
SW01_6
SW01_7
SW01_8
Indoor
unit
capacity
[5] [6] [7] [8] Indoor unit capacity
OFF OFF OFF OFF 0.6HP
OFF OFF OFF
ON 0.8HP (AB072MRERA)
OFF OFF
ON OFF 1.0HP (AB092MRERA)
OFF OFF
ON ON 1.2HP (AB122MRERA)
OFF
ON OFF OFF 1.5HP
OFF
ON OFF ON 1.7HP (AB162MRERA)
OFF
ON ON OFF 2.0HP (AB182MRERA)
OFF
ON ON ON 2.5HP (AB242MRERA)
ON OFF OFF OFF 3.0HP (AB282MRERA)
ON OFF OFF ON 3.2HP (AB302MRERA)
ON OFF ON OFF 4.0HP (AB382MRERA)
ON OFF ON ON 5.0HP (AB482MRERA)
ON ON OFF OFF 6.0HP (AB602MRERA)
ON ON OFF ON 8.0HP
ON ON ON OFF 10.0HP
ON ON ON ON 15.0HP
LED light introduction:
• LED1, LED2: communication lamp between indoor unit and wired controller.
These two lamps icker alternately under normal condition; once occurs the communication faulty, these
two lamps will light or not light at the same time.
• LED3, LED4: communication lamp between indoor unit and outdoor unit.
These two lamps icker alternately under normal condition; once occurs the communication faulty, these
two lamps will light or not light at the same time.
• LED5: malfunction lamp of indoor unit.
This lamp not light under normal condition; once indoor unit occurs malfunction this lamp will icker, icker
times indicate the corresponding failure code.
• LED7: for factory testing.
To Next Page
Loading...
