Hakko Electronics Monitouch V9 Series Troubleshooting Instructions Supplement

2-12 2. Local Mode Screen
IP Address Setting for the V9 Series
When using the Ethernet function, set the IP address for the V9 series unit.
An IP address can be set either on the V9 unit or in the screen program.
Setting on the V9 Unit
1. Press [LAN Setting] in the menu icons and open the [IP Setting] tab window.
2. Set each item.
- When inputting directly:
Press each item and make a setting using the system keyboard.
- When selecting from the network table:
Tap an IP address to select from the network table.
3. Press the [Apply] switch to confirm the setting.
Select [System Information]  [MONITOUCH Information], and check the contents in the
[Ethernet Information] field.
Not used when the gateway or the subnet mask is zero
Not used when the gateway or the subnet mask is zero

Hakko Electronics Monitouch V9 Series Specifications

General

Brand	Hakko Electronics
Model	Monitouch V9 Series
Category	Monitor
Language	English