Hammer K3 winner - Circular Saw Guard

48
!
"
!
"
§
$
%
&
Panel Saw
K3 basic/K3 winner
Making adjustments and preparations
Fig. 59: Fitting the splitter in
1. Loosen the nut.
2. Remove the splitter if required.
3. Fit the splitter in.
Take care that the splitter holder studs fit in the split-
ter groove.
4. Adjust the splitter.
! Nut
" Splitter
The saw guard is mounted onto the splitter. The mounting
depends on the diameter of the saw blade:
• Saw blade recess from 300 up to 315 mm
• Saw blade recess from 250
1. Loosen the thumb nut.
2. Push the hood stud to the back with the thumb nut.
3. Circular saw guard Remove the saw guard and insert
it into the other recess.
4. Secure the thumb nut.
! Splitter
" Hood stud
§ Thumb nut
$ Circular saw guard
% Saw blade recess 300–315 mm
& Saw blade recess 250 mm
8.11 Circular saw guard
Fig. 60: Circular saw guard