!
"
#
$
!
"
§
$
%
&
Panel Saw
K3 basic/K3 winner
Setup and installation
7.3 Assembly
7.3.1 Sliding table
Attention: Due to transport reasons, the sliding table, depending on its length, may be packaged
separately. Two to three additional helpers, depending on the cutting length, are required to install
the machine.
The sliding table has to be set up before the initial
machine start-up. Individual installation instructions
are found with the machine or the sliding table.
7.3.2 Assembling/disassembling the outrigger table
Fig. 32: Assembling the outrigger table
Assembling the outrigger table:
1. Hook the outrigger table into the groove on the slid-
ing table.
2. Place the outrigger table onto the support arbor.
3. Fix with a thumb screw.
Disassemble the outrigger table:
1. Loosen the thumb screw.
2. Unhook the outrigger table from the support arbor
and the sliding table.
!Groove
"Outrigger table
#Support arbor
$Thumb screws
7.3.3 Circular saw guard
Fig. 33: Circular saw guard
! Splitter
" Thumb nut
§ Hood stud
$ Circular saw guard
% Saw blade recess 300–315 mm
& Saw blade recess 250 mm
To Next Page
