Panel Saw
K3 basic/K3 winner
Operation
Warning: Risk of injury!
9.7.11 Groove cuts
• Groove cuts may only be carried out with an over-
head saw guard! Do not use a saw guard!
• Do not pull back the parallel cutting fence‘s guide!
• Do not remove the splitter!
• If the saw blade protrudes from the upper edge of
the parallel cutting fence guide, guiding the work-
Fig. 98: Groove cuts
1. Take note of general procedures for authorised work-
ing techniques.
2. Adjust the parallel cutting fence to the desired meas-
urement.
3. Lock the sliding table into a center position.
4. Set the cutting height to a maximum of half that of
the workpiece thickness!
5. Select the cut sequence so that the cut batten falls
onto the sliding table side.
Should the cut batten fall to the right side of the circu-
lar saw, a wooden push stick has to be used due to
the high kickback risk!
X Work-piece thickness
X/2 Cutting height
piece safely is not guaranteed. A higher auxiliary
fence must be used to ensure that the work-piece is
guided safely.
• When working on small work-pieces, use a wooden
push stick, a push stick or a load feeding accessory.
Fig. 99: Groove cuts
To Next Page
