Hammer K3 winner - Unchucking the Grooving Tools - Retool to a Saw Blade Operation

54
55
"
#
#
"
!
"
#
$
%
&
/
(
Panel Saw
K3 basic/K3 winner
Making adjustments and preparations
8.13.3 Unchucking the grooving tools – Retool to a saw blade operation
Required tools:
• Allen key 10 mm
• Spanner SW 24 mm
• Allen key 4 mm
! Wooden loading board
" Screws
# Allen key
1. Preparing to change tooling.
2. Move the grooving tool to the lowest position.
3. Unscrew the 4 screws with the Allen key.
4. Remove the wooden loading board.
5. Hold the circular saw flange with an open-end
spanner.
6. Loosen the socket head cap screw with an Allen key.
7. Remove the socket head cap screw and flange.
8. Remove the grooving tooling.
Fig. 73: Wooden loading board
Fig. 74: Remove grooving tooling
Fig. 75: Spacer ring/ Saw arbor
$ Allen key
% Grooving tool
& Spanner
9. Remove the spacer ring from the saw blade arbor if
present.
/ Spacer ring
( Saw arbor