64
Panel Saw
K3 basic/K3 winner
Operation
Warning: Risk of injury: Trimming may only take place if using a trimming shoe!
Fig. 89: Trimming with trimming equipment
Using trimming equipment:
1. Take note of general procedures for authorised
working techniques.
2. Mount the trimming equipment (Assembly instructions
„Trimming equipment“).
3. Lock the sliding table.
*)
4. Clamp the unfinished plank, with the hollow side
facing upwards into the trimming equipment.
5. Switch on the circular saw.
6. Feed the trimming equipment and the workpiece
together constantly past the saw blade, keeping
fingers balled into a fist.
*)
*)
The trimming equipment is pushed along the sliding table‘s groove.
9.7.5 Longitudinal cut
1. Take note of general procedures for authorised work-
ing techniques.
2. Adjust the parallel cutting fence to the desired meas-
urement.
3. Lock the sliding table into a center position.
4. Place the workpiece against the parallel cutting
fence.
5. Switch on the circular saw.
6. Switch the scoring unit on, if necessary.
7. Feed the workpiece constantly past the circular saw,
keeping your fingers balled into a fist.
Fig. 90: Longitudinal cut
To Next Page
Loading...
