Hartmann Vivano Tec Pro - Installation Site and Position of the Negative Pressure Unit; Charging the Battery


18
19
IMPORTANT!
• Unpack the negative pressure unit carefully�
• Hold the negative pressure unit securely and do not allow it to fall�
• Only operate the negative pressure unit using the original power supply supplied�
• Time required from minimum or maximum storage temperature to usage temperature is at least
2hours�
Installation site and position of the negative pressure unit
The negative pressure unit can be carried by the patient or installed close to the patient� If the device is installed, ensure
that it is stable and cannot fall down� Please always position the tubing loosely without tension�
The negative pressure unit must not be installed immediately next to, or stacked on top of other devices�
• Place the device as vertically as possible, or hang it up
• at a maximum of 1m above the wound dressing
• height of normal use 1m
• Separable plugged connectors must be made accessible
• Operator’s position (physician or a qualified person) must be in front of the device, facing the display
Charging the battery
IMPORTANT!
Before operating the unit for the first time, the battery
must be fully charged� Only the original power supply and
power supply cable (marked with VivanoTecPro) may be
used for charging� The negative pressure unit should be
charged in a location as cool as possible, away from direct
sunlight� Incorrect procedures can cause severe damage
to the negative pressure unit� Damage caused by incorrect
handling is not covered by the warranty�
> Push the plug of the power supply into the socket on the negative
pressure unit�
> Connect the power supply to the supplied country-specific power
supply cable
�
> Plug the mains plug (means for mains isolation) into the mains
socket
�
The charging symbol is displayed on the negative pressure unit
.
> When the battery is completely charged
, unplug the device
from the mains socket� For this, remove the plug from the mains socket
and remove the power supply plug from the socket on the negative
pressure unit�
> The device can also be operated while still connected to the mains
supply (mains operation)�
IFU_4095080_0302884_190824_EN.indd 18IFU_4095080_0302884_190824_EN.indd 18 19.08.24 12:3119.08.24 12:31