HAWEKA AXIS 500 - Replacing Batteries in the Inclinometer; Error Description; Error Description and Causes

Wheel Alignment AXIS500
AXIS500 Manual Instructions
42
12 Error description
Operator must only correct such malfunctions that evidently result from faulty
operation or maintenance.
12.1 Error description and causes
0B
description
possible causes
1B
error correction
When switching on the system,
the laser point becomes
weaker.
Insufficient charge of
accumulator pack.
Switch off Laser Aligner!
Charge accumulator packs
with included charging unit.
Laser Aligner is not firmly
attached to the rim.
• Dirt on rim surface.
• Dirt on magnetic feet.
• No all-over attachment of
magnetic feet to rim.
Switch off Laser Aligner!
• Clean rim surface.
• Clean surface of
magnetic foot.
• Adjust magnetic foot
again
Battery symbol is indicated
on display of electronic
inclinometer.
Insufficient charge of
integrated battery.
Open casing lid with
appropriate screw driver and
replace battery.
Measured values cannot be
repeated.
• Defective adjustment of
laser measuring head
• Faulty calibration
Check as on page 40
Adjustment of laser
measuring head. Please call
your HAWEKA distributor!