Wheel Alignment AXIS500
AXIS500 Manual Instructions
This symbol indicates no safety concerns but
information’s for a better understanding of operating
cycles.
Symbols attached to laser measuring heads are placed close to laser beam output
opening.
Laser radiation warning
This symbol indicates that, above all, dangers to
people are to be expected.
Information sign with the laser class markings
1.3 General safety measures
Laser Aligner AXIS500 must only be operated by suitably
trained and authorized personnel that is familiar with these
operating instructions and capable of proper
implementation.
Check Laser Aligner before any operation for visual damage
and ensure proper functionality of device! In case of defect
inform manager of workshop!
Laser
CLASS 2
TYP 1
Laser devices require general considerations:
- Do never look directly into laser beam!
- Define laser beam paths accurately, use laser absorbing
means to avoid stray laser irradiation! Hazardous
reflections are particularly caused by reflecting and
shining surfaces.
- Level laser beam path above or below eye level if
possible!
- Laser beam paths should not cross operational areas. If
this is inevitable mark laser operating area significantly
and set up required warning signs.
- Switch off laser after operation!
You can find more safety precautions in:
Safety of laser products; Part 1: Equipment classification,
requirements and user’s guide (IEC 825-1:1993)
It is the responsibility of the operator to ensure proper
operation and implementation of safety precautions.
To Next Page
Loading...