6.8 Perception Software
Perception Software is installed on your GEN3i for control, analysis, archiving
and reporting.
The GEN3i has two modes of operation. During operation, you can choose
between these two modes.
Primary mode:
l
Instrument Panel - for daily use
Secondary mode:
l
Standard Perception - For post-processing
The Instrument Panel is the dedicated touch screen software interface which
has been specifically designed for GEN3i as the normal mode of operation.
However,
you can switch to Standard Perception for on-board post-processing
at any time.
GEN3i
I3763-3.1 en HBM: public 89
To Next Page
Loading...
