Machine mode of operation | Machine data
4
100
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Machine with counter spindle
You have to select a workpiece spindle depending on the machine.
If your machine is equipped with a counter spindle, the WP
parameter is shown in the TSF dialog.
Cycle parameters:
WP: No. of spindle (machine-dependent)
The WP parameter allows you to select the workpiece spindle
for machining in Teach-in submode and with the MDI cycles of
Machine mode of operation.
Select the workpiece spindle for machining with WP:
Main drive
Counter spindle for rear-face machining
The WP parameter setting is saved in the Teach-in and MDI cycles
and displayed in the corresponding cycle form.
If you selected the counter spindle for rear-face machining with the
WP parameter, the cycle is mirrored (in the opposite Z direction).
Use tools with suitable tool orientation.
In the TSF menu, the setting for the WP parameter is
changed when you:
Run a cycle with another WP parameter setting
Select a program in Program run submode
To Next Page
Loading...
