Machine mode of operation | Machine data
4
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
99
TSF entry via a form
For machines with a tool magazine, separate dialogs are
automatically available.
Entering the tool data and technology data:
Select Set T, S, F (can only be selected in
Machine mode of operation)
Define the parameters
Press the Save soft key
NOTICE
Danger of collision!
Depending on the machine, the input of data in the T dialog
might cause a tilting movement of the tool carrier (e.g. turret).
There is a danger of collision during the tilting movement!
Move the tool or the tool carrier to a safe position before
entering data
TSF entry via separate forms
Entering the tool data or technology data:
Select Set T, S, F (can only be selected in
Machine mode of operation)
Select T for tool change
Alternative: Select S for spindle speed
Alternative: Select F for feed rate
Enter the parameters in the submenu
Press the Save soft key
NOTICE
Danger of collision!
Depending on the machine, the input of data in the T dialog
might cause a tilting movement of the tool carrier (e.g. turret).
There is a danger of collision during the tilting movement!
Move the tool or the tool carrier to a safe position before
entering data
To Next Page
Loading...
