Machine mode of operation | Program run submode
4
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
149
Variables
Refer to your machine manual.
This feature must be enabled and adapted by the
machine tool builder.
In Program run submode, it is possible to display and edit the
variables defined in the PROGRAM HEAD program section.
Further information: smart.Turn and DIN Programming User's
Manual
Displaying or hiding Variables:
Select the Flow menu item
Select the Variables menu item
Select the Output on menu item
The Variables pop-up window is displayed.
Alternative: Select the Output off menu item
The Variables pop-up window is hidden.
Changing Variables:
Select the Flow menu item
Select the Variables menu item
Select the Change menu item
If the Variables pop-up window is not visible, it
will be displayed now.
You can now change the variables as desired.
Please note that you can only change variables while the
program is not running (not started yet or stopped).
To Next Page
Loading...
