Fundamentals | Software and features
20
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
In Tool editor operating mode, the Tool radius 2 R2 and Tool
radius 2 oversize DR2 tool parameters were added for standard
milling cutters, see "Standard milling tools", Page 589
In Tool editor operating mode, the CA1 and CA2 tool
parameters (calibration values) were added for 3-D touch
probes, see "Touch probes", Page 594
In Tool editor operating mode, the Halter Tiefe WHT and
Versatz für Tiefe TOF parameters were added to the tool
holder dialogs, see "Holder editor", Page 571
The Delete all soft key was added to the Table of the tool
holder, see "Holder editor", Page 571
The Save and Cancel soft keys were added to the Tool text list,
see "Tool texts", Page 565
The Turret assignment and Magazine list now display the LA,
XL and ZL columns.
By pressing the arrow keys, you can navigate to the next or
previous column within the Turret assignment and Magazine
list.
In order to allow you to transfer screenshots (created with
the PRT SC key) in Transfer operating mode, the Select TNC:
soft key was added to the Service section, see "Transferring
programs (files)", Page 659
To check the usable length of the cutting edge for finishing
operations, the checkCuttingLength (602322) machine
parameter was added, see "List of machine parameters",
Page 608
In order to suppress the Residual material due to cutting
edge geometry! warning, we added the suppressRestMatWar
(201010) machine parameter, see "List of machine parameters",
Page 608
To automatically load the program last used in Program run
submode, the autoPgmSelect (601814) machine parameter
was added, see "List of machine parameters", Page 608, see
"Loading a program", Page 142
The DefaultG14 machine parameter was extended to include
additional traverse options to the G14 tool change position, see
"List of machine parameters", Page 608
With the G function for engraving, you can
engrave the date and time using variables,
see the smart.Turn and DIN Programming User's Manual
Contents of variables can be converted to string variables,
see the smart.Turn and DIN Programming User's Manual
Touchscreen operation is supported, see "Operating the
Touchscreen", Page 83
Operation of the new HR 520 and HR 550FS electronic
handwheels is supported, see "Configuring the HR 550FS
wireless handwheel", Page 128
The machine tool builder can extend the machine data display to
5 lines on 19" screens, see "Machine data display", Page 102
On 19” screens, the Transfer machine
soft key is located in the first soft-key row,
see the smart.Turn and DIN Programming User's Manual
To Next Page
Loading...
