Fundamentals | Software and features
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
21
The machine tool builder can make custom G
functions available to the user in the G menu,
see the smart.Turn and DIN Programming User's Manual
The machine tool builder can provide machine-specific start
units, see the smart.Turn and DIN Programming User's Manual
The machine tool builder can make custom units available to the
user, see the smart.Turn and DIN Programming User's Manual
The machine tool builder can make
program templates available to the
user, ,see the smart.Turn and DIN Programming User's Manual
In the PROGRAM HEAD program section,
you can specify up to 20 global variables,
see the smart.Turn and DIN Programming User's Manual
The Delete history soft key was added to the PROGRAM HEAD
dialog, see the smart.Turn and DIN Programming User's Manual
New Bore milling G75 G function,
see the smart.Turn and DIN Programming User's Manual
New Information to DNC G941 G function,
see the smart.Turn and DIN Programming User's Manual
New LIFTOFF G977 G function,
see the smart.Turn and DIN Programming User's Manual
The G14 G function was extended to include
additional traverse options to the tool change position,
see the smart.Turn and DIN Programming User's Manual
The Slide mov.diff. B parameter was
added to the G810 and G820 G functions,
see the smart.Turn and DIN Programming User's Manual
The Workpc. blank contour RH parameter was added to
the G810, G820, G830, and G835 G functions and units,
see the smart.Turn and DIN Programming User's Manual
The Mirror writing O parameter was added to the
G801, G802, G803, and G804 G functions and units ,
see the smart.Turn and DIN Programming User's Manual
Functions changed in software 54843x-05
Start blck search is not available for Reference machining
operations required during load monitoring (option), see "Block
scan", Page 145
The input range of the DX, DY, DZ, and DS tool parameters was
extended to 4 decimal places (mm) and 5 decimal places (inch),
see "General tool parameters", Page 576
The magazine list displays the Pocket type (PTYP/T column) and
the PLC settings (PTYP/M column).
The input range of the Overlap factor U cycle parameter was
extended to 0.99 for milling cycles.
In order to avoid unwanted data loss, the default setting for
Parameter restore was set to Pocket table No.
To Next Page
Loading...
