HEIDENHAIN 548431-05 - Page 450

ICP programming | Contour elements – turning contour
6
450
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Vertical lines
Programming a vertical line:
Select the line direction
Enter the line dimensions
Define the transition to the next contour element
Parameters:
X: Target point
Xi: Target point (incremental)
W: Target point (polar angle)
P: Target point (polar; radius)
L: Line length
U, F, D, FP, IC, KC, HC:
Further information: "Machining attributes", Page 418
ICP generates a G1 in smart.Turn mode of operation.
Horizontal lines
Programming a horizontal line:
Select the line direction
Enter the line dimensions
Define the transition to the next contour element
Parameters:
Z: Target point
Zi: Target point (incremental)
W: Target point (polar angle)
P: Target point (polar; radius)
L: Line length
U, F, D, FP, IC, KC, HC:
Further information: "Machining attributes", Page 418
ICP generates a G1 in smart.Turn mode of operation.