ICP programming | Contour elements – turning contour
6
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
451
Line at angle
Programming a line at an angle:
Select the line direction
Enter the line dimensions
Define the transition to the next contour element
Always enter the angle AN within the selected quadrant (<=90°).
Parameters:
X, Z: Target point
Xi, Zi: Target point (incremental)
W: Target point (polar angle)
P: Target point (polar; radius)
L: Line length
AN: Angle to Z axis
ANn: Angle to Z axis – Angle to the subsequent element
ANp: Angle to Z axis – Angle to the previous element
U, F, D, FP, IC, KC, HC:
Further information: "Machining attributes", Page 418
ICP generates a G1 in smart.Turn mode of operation.
To Next Page
Loading...
