HEIDENHAIN 548431-05 - Page 461

ICP programming | Contour elements – front face
6
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
461
Vertical lines on front face
Programming vertical lines:
Select the line direction
Enter the line dimensions
Define the transition to the next contour element
Parameters:
YK: Target point (in Cartesian coordinates)
YKi: Target point (incremental) – Distance between starting
point and Target point
C: Target point (polar angle)
P: Target point (in polar coordinates)
L: Line length
F: Further information: "Machining attributes", Page 418
ICP generates a G101 in smart.Turn mode of operation.
Horizontal lines on front face
Programming horizontal lines:
Select the line direction
Enter the line dimensions
Define the transition to the next contour element
Parameters:
XK: Target point (in Cartesian coordinates)
XKi: Target point (incremental) – Distance between starting
point and Target point
C: Target point (polar angle)
P: Target point (in polar coordinates)
L: Line length
F: Further information: "Machining attributes", Page 418
ICP generates a G101 in smart.Turn mode of operation.