ICP programming | Contour elements – front face
6
462
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Line at angle on front face
Programming a line at an angle:
Select the line direction
Enter the line dimensions
Define the transition to the next contour element
Parameters:
XK, YK: Target point (in Cartesian coordinates)
XKi, YKi: Target point (incremental) – Distance between
starting point and Target point
C: Target point (polar angle)
P: Target point (in polar coordinates)
L: Line length
AN: Angle to positive XK axis
ANn: Angle to the subsequent element
ANp: Angle to the previous element
F: Further information: "Machining attributes", Page 418
ICP generates a G101 in smart.Turn mode of operation.
To Next Page
Loading...
