ICP programming | Contours in the XY plane
6
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
505
Hole in XY plane
This function defines a single hole that can contain the following
elements:
Centering
Hole
Cavity
Thread
Reference data of hole:
ID: Contour
C: Spindle angle
IR: Limit diameter
ZR: Reference dimension
Parameters of hole:
XM, YM: Center
Centering
O: Diameter
Hole
B: Diameter
BT: Depth (without algebraic sign)
W: Angle
Cavity
R: Diameter
U: Depth
E: Sink angle
Thread
GD: Diameter
GT: Depth
K: Cut-in length
F: Thread pitch
GA: Thread direction
0: Right-hand thread
1: Left-hand thread
You can use the Select reference plane function to determine the
Reference dimension ZR and the Limit diameter IR.
Further information: "Reference data and nested contours",
Page 472
ICP generates the following:
The FRONT Y section code with the Limit diameter, Reference
dimension, and Spindle angle parameters. The section code is
omitted for nested contours.
a G308 with the Contour name and Boring depth (–1*BT)
parameters
A G370 with the parameters of the hole
A G309
To Next Page
Loading...
