ICP programming | Contours in the XY plane
6
506
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Linear pattern in XY plane
Reference data of XY plane:
ID: Contour
PT: Milling depth
C: Spindle angle
IR: Limit diameter
ZR: Reference dimension
Parameters of pattern:
X, Y: 1st pattern point
QP: Quantity of points in pattern
IP, JP: Final point of pattern (in Cartesian coordinates)
IPi, JPi: Final point – Distance between two pattern points (in X
and Y)
AP: Position angle
RP: Length – Total length of pattern
RPi: Length – Distance between two pattern points
Parameters of the selected figure/hole
You can use the Select reference plane function to determine the
Reference dimension ZR and the Limit diameter IR.
Further information: "Reference data and nested contours",
Page 472
ICP generates the following:
The FRONT Y section code with the Limit diameter, Reference
dimension, and Spindle angle parameters. The section code is
omitted for nested contours.
a G308 with the Contour name and Milling depth or Boring
depth (–1*BT) parameters
A G471 with the parameters of the pattern
The G code and the parameters of the figure/hole
A G309
To Next Page
Loading...
