Organization mode of operation | Parameters
9
616
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Settings for fixed cycles and units
0: Full-surface roughing cycle, including plunge-cutting
1: Standard roughing cycle, without plunge-cutting
Machining – outside/transverse [RAP] (602211): Roughing strategy
0: Full-surface roughing cycle, including plunge-cutting
1: Standard roughing cycle, without plunge-cutting
Machining – inside/transverse [RIP] (602212): Roughing strategy
0: Full-surface roughing cycle, including plunge-cutting
1: Standard roughing cycle, without plunge-cutting
Secondary angle tolerance [RNWT] (602213)
[°]: Tolerance range for secondary tool cutting edge
Relief cutting angle [RFW] (602214)
[°]: Minimum difference between contour and secondary cutting edge
Oversize type [RAA] (602215)
16: Different longitudinal/transverse oversizes – no individual oversizes
32: Equidistant oversize – no individual oversizes
144: Different longitudinal/transverse oversizes – with individual oversizes
160: Equidistant oversize – with individual oversizes
Equidistant or longitudinal [RLA] (602216)
[mm]: Equidistant oversize or longitudinal oversize
Traverse oversize [RPA] (602217)
[mm]: Traverse oversize
Approach/outside roughing [ANRA] (602218): Approach strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Approach/inside roughing [ANRI] (602219): Approach strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Departing/outside roughing [ABRA] (602220): Departing strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Departing/inside roughing [ABRI] (602221): Departing strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
To Next Page
Loading...
