Organization mode of operation | Parameters
9
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
615
Settings for fixed cycles and units
Safety clearance to workpiece blank [SAB] (602108)
[mm]: Safety clearance to workpiece blank
Safety clearance, inside [SIB] (602109)
[mm]: Retraction clearance for deep drilling (B in G74)
Drilling depth ratio [BTV] (602110)
Ratio for checking the predrilling passes (BTV <= BT/dmax)
Drilling depth factor [BTF] (602111)
Factor for the calculation of the first drilling depth for deep drilling (bt1 = BTF*db)
Drilling depth reduction [BTR] (602112)
[mm]: Reduction for deep drilling (bt2 = bt1 – lBTR)
Overhang length – predrilling [ULB] (602113)
[mm]: Default value for spot drilling/through hole A
Processing
Roughing (602200)
Tool angle – outside/longitudinal [RALEW] (602201)
[°]: Tool angle for roughing tool
Point angle – outside/longitudinal [RALSW] (602202)
[°]: Point angle for roughing tool
Tool angle – outside/transverse [RAPEW] (602203)
[°]: Tool angle for roughing tool
Point angle – outside/transverse [RAPSW] (602204)
[°]: Point angle for roughing tool
Tool angle – inside/longitudinal [RILEW] (602205)
[°]: Tool angle for roughing tool
Point angle – inside/longitudinal [RILSW] (602206)
[°]: Point angle for roughing tool
Tool angle – inside/transverse [RIPEW] (602207)
[°]: Tool angle for roughing tool
Point angle – inside/transverse [RIPSW] (602208)
[°]: Point angle for roughing tool
Machining – outside/longitudinal [RAL] (602209): Roughing strategy
0: Full-surface roughing cycle, including plunge-cutting
1: Standard roughing cycle, without plunge-cutting
Machining – inside/longitudinal [RIL] (602210): Roughing strategy
To Next Page
Loading...
