Organization mode of operation | Parameters
9
614
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Settings for fixed cycles and units
Conversion of ICP contours (602023)
0: Read out calculated parameters
1: Read out programmed parameters
Generate contour groups (602024)
OFF: The AWG does not generate contour groups
ON: The AWG generates two contour groups when performing full-surface machin-
ing at the main and counter spindle
Generate structure program (602025)
OFF: The AWG does not generate a structural program
ON: The AWG generates a structural program
Delete contour group at counter spindle (602026)
OFF: The contour group at the counter spindle will not be deleted
ON: The AWG deletes the contour group at the counter spindle
Processing
Global parameters for finished parts (601900)
Max. inward copying angle (EKW) (601903)
[°]: Limit angle for the distinction between turning and recessing
Processing
Centric predrilling (602100)
First drill limit diameter [UBD1] (602101)
[mm]: Limit diameter for the first predrilling pass
Second drill limit diameter [UBD2] (602102)
[mm]: Limit diameter for the second predrilling pass
Point angle tolerance [SWT] (602103)
[°]: Permissible point angle deviations for oblique drilling limit elements
Drilling oversize – diameter [BAX] (602104)
[mm]: Machining oversize for drilling diameter in X-direction (radius dimension)
Drilling oversize – depth [BAZ] (602105)
[mm]: Machining oversize for drilling depth in Z-direction
Approach to predrilling [ANB] (602106): Approach strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Departure for tool change [ABW] (602106): Departing strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
To Next Page
Loading...
