Organization mode of operation | Parameters
9
618
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Settings for fixed cycles and units
Tool angle – inside/transverse [FIPEW] (602307)
[°]: Tool angle for finishing tool
Point angle – inside/transverse [FIPSW] (602308)
[°]: Point angle for finishing tool
Machining – outside/longitudinal [FAL] (602309): Finishing strategy
0: Full-surface finishing cycle, with optimum tool
1: Standard finishing cycle; relief turns and undercuts with suitable tool
Machining – inside/longitudinal [FIL] (602310): Finishing strategy
0: Full-surface finishing cycle, with optimum tool
1: Standard finishing cycle; relief turns and undercuts with suitable tool
Machining – outside/transverse [FAP] (602311): Finishing strategy
0: Full-surface finishing cycle, with optimum tool
1: Standard finishing cycle; relief turns and undercuts with suitable tool
Machining – inside/transverse [FIP] (602312): Finishing strategy
0: Full-surface finishing cycle, with optimum tool
1: Standard finishing cycle; relief turns and undercuts with suitable tool
Secondary angle tolerance [FNWT] (602313)
[°]: Tolerance range for secondary tool cutting edge
Relief cutting angle [FFW] (602314)
[°]: Minimum difference between contour and secondary cutting edge
Approach/outside finishing [ANFA] (602315): Approach strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Approach/inside finishing [ANFI] (602316): Approach strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Departing/outside finishing [ABFA] (602317): Departing strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Departing/inside finishing [ABFI] (602318): Departing strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
To Next Page
Loading...
