HEIDENHAIN 548431-05 - Page 619

Organization mode of operation | Parameters
9
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
619
Settings for fixed cycles and units
Min. finishing transverse length [FMPL] (602319)
[mm]: Dimension for determination of the machining type
Max. Finishing cutting depth [FMST] (602320)
[mm]: Permissible plunging depth for unmachined undercuts
Revolutions for chamfer/rounding [FMUR] (602321)
Minimum number of revolutions, the feed rate is automatically reduced
Check of cutting edge length (602322)
On: Checks whether the usable length of the cutting edge is sufficient for machining
Off: No check whether the usable length of the cutting edge is sufficient for machin-
ing
Processing
Recessing (602400)
Approach/outside recessing [ANESA] (602401): Approach strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Approach/inside recessing [ANESI] (602402): Approach strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Departing/outside recessing [ABESA] (602403): Departing strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Departing/inside recessing [ABESI] (602404): Departing strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Approach/outside contour recessing [ANKSA] (602405): Approach strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Approach/inside contour recessing [ANKSI] (602406): Approach strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Departing/outside contour recessing [ABKSA] (602407): Departing strategy
1: XZ – Simultaneously