Organization mode of operation | Parameters
9
620
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Settings for fixed cycles and units
2: XZ – Sequentially
3: ZX – Sequentially
Departing/inside contour recessing [ABKSI] (602408): Departing strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Recessing width divisor [SBD] (602409)
Value for the selection of the tool for contour recessing with linear elements at the
bottom of the recess
Oversize type [KSAA] (602410)
16: Different longitudinal/transverse oversizes – no individual oversizes
32: Equidistant oversize – no individual oversizes
144: Different longitudinal/transverse oversizes – with individual oversizes
160: Equidistant oversize – with individual oversizes
Equidistant or longitudinal [KSLA] (602411)
[mm]: Equidistant oversize or longitudinal oversize
Traverse oversize [KSPA] (602412)
[mm]: Traverse oversize
Recessing width factor [SBF] (602413)
Factor for determination of the maximum tool offset
Recessing/Finishing (602414): Sequence of finishing cuts
1: Divide floor element (previous behavior)
2: Move through and lift-off
Processing
Thread cutting (602500)
Approach/thread cutting, outside [ANGA] (602501): Approach strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Approach/thread cutting, inside [ANGI] (602502): Approach strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
Departing/thread cutting, outside [ABBS] (602503): Departing strategy
1: XZ – Simultaneously
2: XZ – Sequentially
3: ZX – Sequentially
To Next Page
Loading...
