Organization mode of operation | Parameters
9
642
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Drilling – Machining
The parameters apply to drilling with deep-hole drilling cycle (G74).
Machining
Parameter Meaning
Drilling depth factor BTFC 1st drilling depth: bt1 = BTFC
* db (db: Drill diameter)
Depth reduction BTRC 2nd drilling depth: bt2 = bt1 –
BTRC
The subsequent drilling steps
are reduced accordingly
Diameter tolerance for drill BDT
For selecting the desired drill
(centering drills, countersinks,
stepped drill, taper reamers).
Drilling diameter: DBmax =
BDT + d (DBmax: Maximum
drilling diameter)
Tool selection: DBmax > DB
> d
To Next Page
Loading...
