HEIDENHAIN TNC 320 - Page 33

HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
33
14 Touch Probe Cycles: Automatic Datum Setting........................................................................ 323
14.1 Fundamentals...................................................................................................................................... 324
Overview............................................................................................................................................... 324
Characteristics common to all touch probe cycles for datum setting...................................................326
14.2 DATUM SLOT CENTER (Cycle 408, DIN/ISO: G408).........................................................................328
Cycle run............................................................................................................................................... 328
Please note while programming:..........................................................................................................329
Cycle parameters.................................................................................................................................. 330
14.3 DATUM RIDGE CENTER (Cycle 409, DIN/ISO: G409).......................................................................332
Cycle run............................................................................................................................................... 332
Please note while programming:..........................................................................................................332
Cycle parameters.................................................................................................................................. 333
14.4 DATUM FROM INSIDE OF RECTANGLE (Cycle 410, DIN/ISO: G410).............................................. 335
Cycle run............................................................................................................................................... 335
Please note while programming:..........................................................................................................336
Cycle parameters.................................................................................................................................. 337
14.5 DATUM FROM OUTSIDE OF RECTANGLE (Cycle 411, DIN/ISO: G411).......................................... 339
Cycle run............................................................................................................................................... 339
Please note while programming:..........................................................................................................339
Cycle parameters.................................................................................................................................. 340
14.6 DATUM FROM INSIDE OF CIRCLE (Cycle 412, DIN/ISO: G412)...................................................... 342
Cycle run............................................................................................................................................... 342
Please note while programming:..........................................................................................................343
Cycle parameters.................................................................................................................................. 344
14.7 DATUM FROM OUTSIDE OF CIRCLE (Cycle 413, DIN/ISO: G413).................................................. 347
Cycle run............................................................................................................................................... 347
Please note while programming:..........................................................................................................347
Cycle parameters.................................................................................................................................. 348
14.8 DATUM FROM OUTSIDE OF CORNER (Cycle 414, DIN/ISO: G414)................................................351
Cycle run............................................................................................................................................... 351
Please note while programming:..........................................................................................................352
Cycle parameters.................................................................................................................................. 353