HEIDENHAIN TNC 320 - Page 34

Contents
34
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
14.9 DATUM FROM INSIDE OF CORNER (Cycle 415, DIN/ISO: G415)....................................................356
Cycle run............................................................................................................................................... 356
Please note while programming:..........................................................................................................357
Cycle parameters.................................................................................................................................. 358
14.10DATUM CIRCLE CENTER (Cycle 416, DIN/ISO: G416)..................................................................... 360
Cycle run............................................................................................................................................... 360
Please note while programming:..........................................................................................................360
Cycle parameters.................................................................................................................................. 361
14.11 DATUM IN TOUCH PROBE AXIS (Cycle 417, DIN/ISO: G417)..........................................................363
Cycle run............................................................................................................................................... 363
Please note while programming:..........................................................................................................363
Cycle parameters.................................................................................................................................. 364
14.12DATUM AT CENTER OF 4 HOLES (Cycle 418, DIN/ISO: G418)........................................................365
Cycle run............................................................................................................................................... 365
Please note while programming:..........................................................................................................366
Cycle parameters.................................................................................................................................. 367
14.13DATUM IN ONE AXIS (Cycle 419, DIN/ISO: G419)...........................................................................369
Cycle run............................................................................................................................................... 369
Please note while programming:..........................................................................................................369
Cycle parameters.................................................................................................................................. 370
14.14Example: Datum setting in center of a circular segment and on top surface of workpiece.........372
14.15Example: Datum setting on top surface of workpiece and in center of a bolt hole circle............373